This ist not really a bug, but it is bugging me:

The new work units seem to have only very few "saving points"

Which means, you put half an hour or even an hour of crunching in, shut down the computer for some reason and when you get back to runching, you have to start over again..

I had this happen at least three times, so I wonder if there is any possibility to put more save spots in the WUs for the crunchers who are not running 24/7 ???

Greets Thor[Free-DC]

You are already using the version that has had checkpoints added. Originally the checkpoints only were done at the end of a full model. Now they are every ~20 min.

There will be a better way to tell when checkpoints occur in future versions, but they cannot add more checkpoints. This is just a limitation of the nature of the work at this time. It should only be falling back to the last checkpoint, not starting over. Unless of course you are shutting down when the percent complete is 1.04x%, then it will start over form the start because it has not check-pointed yet.