1)
Questions and Answers :
Unix/Linux :
Rosetta at SD card
(Message 77430)
Posted 30 Aug 2014 by r98AeGe8Z85Nc8tZ8GT9kuJaZP8 Post: I let Boinc 4GB space and I think its enough for the jobs. However, on SSD CPU usage displays high I/O CPU usage. I check the SMART data of SSD, it logs the read and written amount of data. While running rosetta@home there is enormous increase in written data value. Next time I'll have a look at the work sizes too. As a mod, can you move the thread to NC forum, as it will only dublicate content to reopening it there? |
2)
Questions and Answers :
Unix/Linux :
Rosetta at SD card
(Message 77425)
Posted 28 Aug 2014 by r98AeGe8Z85Nc8tZ8GT9kuJaZP8 Post: Hi. I've an SSD on my notebook and don't want to wear it using Boinc. So I installed Boinc on a 8GB SD card and running on it. It runs Gpugrid and Einstein, WCG, CP etc. normally. However, on rosetta@home, tasks can't start, stop even run due to I/O wait. It waits long time and CPU usage shows high I/O. When I run it on an SSD, rosetta works can write GB of data in some minutes. Why it is using the disk so much, and what can I do to decrease the writes. Work checkpoints are set to be set in 300secs. However, it even can't start crunching them... |
©2024 University of Washington
https://www.bakerlab.org